EasyManuals Logo

Labrie expert 2000 Operator's Manual

Labrie expert 2000
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
47Expert(t) 2000
TM
Operator Manual
Note:To put the floor riser back in
its vertical position, apply the
above procedure, from step 3
to step 1.
Unloading the Body
When the body of the Expert(t) 2000
TM
is full, you proceed to unload it in the
corresponding landfill. The unloading
procedure recommended by Labrie
helps you carry out this operation in a
timely and safely manner.
To unload the body:
1. Drive the vehicle to the desired
dumping site.
2. Make sure the vehicle is on safe,
stable and level ground.
3. Apply the parking brake, get off
the cab and remove the tailgate
safety pins.
4. Back in the cab, use the lever on
the console to fully open the
tailgate.
Figure 36. Unloading the Expert(t)
2000
TM
5. Raise the body. Waste starts to
slide out as the body raises.
Tip: You can throttle to rev up
the engine and speed up
WARNING
ALWAYS CHECK FOR OVERHEAD
CLEARANCE
BEFORE OPENING
THE
TAILGATE AND LIFTING THE
BODY.
Body control
lever
Pull up the
yellow lock,
then move
the lever
sideways to
either raise
or lower the
body.
Tailgate control lever
Pull up the
yellow lock,
then move
the lever
sideways to
either raise
or lower the
tailgate.

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals