Connecng to PC/Mac during an Easy copy or Copilot BOSS app acon
DJI Copilot can be connected to a PC/Mac while it’s performing an Easy copy or Copilot BOSS file
management activities such as copying, moving, or deleting files. DJI Copilot’s drive becomes available to
the PC/Mac when:
1. The action runs to completion.
2. DJI Copilot enters power-saving mode.
A single push is required to connect DJI Copilot to the PC/Mac.
Power
DJI Copilot receives power via:
Its power outlet using the included power cable: 1.5A
A USB-C connection to a computer: Varies by computer power delivery
Charging your mobile device
Typically you’ll want to connect your mobile device to DJI Copilot’s mobile device port using the included
tethered cable, as this allows you to easily manage your data using the Copilot BOSS app.
You can also connect your mobile device to DJI Copilot’s USB Type A port. DJI Copilot delivers 1.5A power
via a USB Type A connection. Micro-USB devices can only accept 900mA.
It’s strongly recommended that you connect your mobile device to DJI Copilot using the
dedicated tethered cable. This allows you to manage data on DJI Copilot and your mobile device
with the Copilot BOSS app.
Use only the power cable provided with your device. Power cables from other DJI,
LaCie, and third-party devices can damage your DJI Copilot.
The Copilot BOSS app only connects to DJI Copilot when the mobile device uses the tethered
cable. The app cannot manage data on DJI Copilot when the mobile device is connected to the
USB Type A port.
To Next Page