HULL / DECK
21
2
HULL / DECK
n 2.7 Anchoring
l
WINDLASS
The electric windlass works with the 12 V domestic batteries.
Activate the windlass using its control located in the starboard side
locker on the front deck.
If the electrical windlass does not function properly, check its
automatic breaker located in the starboard passageway cupboard.
For the maintenance of the windlass, please refer to the manufacturer’s
guide.
l
PREPARING ANCHORING
Set the strop fastening it to the chainplates at the ends of the main
beam.
Insert the strop inside the stem anchor roller.
Make fast the strop to the central cleat when lowering the chain.
n 2.5 Gangway (optional extra)
The boat may optionally be fitted with a foldable carbon gangway.
Remove, store and stow the gangway when sailing.
n 2.6 Steering system
The steering system is made up of steering cables (stainless steel
cables) and two quadrants.
You can reach it through the engine compartments both starboard
and port sides.
The suspended rudders are fitted with stainless steel stocks.
Only WD 40 should be used to maintain nylon ertalon or teflon
bushings.
Please refer to Chapter ‘SAFETY’ as for the emergency tiller use.
LAGOON 42
RECOMMENDATION
Use the electric windlass when one or two engines
are operating.
WARNING
Do not use the gangway as a diving board.
RECOMMENDATION
Before you anchor, check the type of the sea bed,
the depth of water and the strength of the stream.
To Next Page
Loading...
