EasyManua.ls Logo

Lagoon 42 - Deckwash Pump

Lagoon 42
122 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HULL / DECK
23
2
HULL / DECK
n 2.8 Deckwash pump (optional extra)
The deck wash pump is located in the port engine compartment.
It can provide sea water or fresh water coming from the tank.
The freshwater / seawater selector valve, the seacock and the pump’s
power switch are located in the port engine compartment.
l
ANCHORING
Have your boat head wind and without speed.
Pay out the chain while moving back slowly.
Secure the chain on the strop.
Release the chain until the strop is taut.
Pay attention to the swinging space when mooring.
l
RAISING THE GROUND TACKLE
Check the chain is properly set on the grab.
Operate the windlass setting it to the ‘upward’ position.
Slowly go near the anchor using the engine (do not use the windlass
force to winch up the boat).
Visually check the final metres until the anchor gets into contact with
the anchor fairlead.
Check the position of the anchor on the stem fitting.
Rinse the windlass and the ground tackle with fresh water after each
trip.
In case of electric failure, use the winch handle on the windlass to
raise the ground tackle.
Refer to the manufacturer’s instructions for windlass maintenance.
LAGOON 42
WARNING
Windlass operations are dangerous:
- Always keep the ground takle clear and free.
- Always proceed with care, wearing gloves and
always wearing shoes.
- Make sure that nobody leans on the windlass when
operating the control.

Table of Contents

Related product manuals