CHAPTER3 ACCES TO SUPERVISOR MENU
NT_820_910_1300_LX_ANG_V1 04_2007.doc
22
1.ACCES TO SUPERVISOR MENU
Switch on the machine by pressing .
The display indicates the number of the last cycle performed.
P r o g r a m n ° 0 1
L A N C E R x x x x L X
Press and hold button for 3 seconds to validate.
A C C E S S C O D E
----
Enter the access code - SUPERVISOR -.
If an incorrect code is entered, the following error message is displayed.
A C C E S S C O D E
I N C O R R E C T C O D E
Press and hold
button for 3 seconds to validate.
You must enter the correct access code.
Otherwise you access to supervisor menu.
S U P E R V I S O R M E N U
C o n f i g u r a t i o n s
Note :
If the access code is not entered within 30 seconds, the display unit
returns to its initial state.
To Next Page
Loading...
