CHAPTER 4 FAULT ALARMS
NT_820_910_1300_LX_ANG_V1 04_2007.doc
44
1. WARNINGS
1.1 - LACK OF SALT * :
* only for washers with regeneration
(not applicable on 820 LX)
WARNING
L A C K O F S A L T
Lack of salt definition: The following message is displayed at the start
of the cycle when you press the key.
Corrective Action :Fill the salt pot located inside the washer.
1.2 - LACK OF PRODUCTS
WARNING
L A C K O F C H E M I C .
Lack of product definition : The following message is displayed at the
start of the cycle when you press the
key.
Corrective Action :Check level of additive tanks, replace additive low
level tank.
1.3 HOT CHAMBER
W
A R N I N G !
H O T C H A M B E R
INCIDENT: the following message is displayed if the temperature inside
the washing chamber is above the safety temperature set point for door
opening.
ACTION: At the end of the cycle, let the washer chamber and contents
cool before opening the chamber door.
To Next Page
Loading...
