CHAPTER 4 FAULT ALARMS
NT_820_910_1300_LX_ANG_V1 04_2007.doc
46
2.FAULT ALARMS
These alarms stop the operation of the washer. To clear the alarm mode, the
washer must be switched off by pressing button.
2.1 FAULT N°1 PROBE FAULT.
F A U LT N°01
P R O B E D E F E C T
Probe Fault Definition :
The probe used to check the temperature of the water in the chamber
is disconnected or defective.
Corrective Action :
CONTACT A MAINTENANCE TECHNICIAN to check the electrical
connection and the condition of the probe.
2.2 FAULT N°2 EMPTYING FAULT.
F A U LT n°02
E M P T Y I N G F A U L T
Emptying Fault Definition :
The washer has not been fully emptied at the end of the normal
emptying time defined in the Common Times menu.
Corrective Action :
Check that there is no restriction on the emptying line, that the
emptying pump (or the valve) and its pipes are not blocked and that the
chamber filters are not clogged.
This message may be displayed at the end of PREWASH 1, PREWASH 2,
WASH, RUNNING WATER RINSE 1, ACID RINSE, RUNNING WATER RINSE 2, COLD DEMI.
WATER RINSE and HOT DEMI. WATER RINSE.
To Next Page
Loading...
