Lanier 5222 - Setting up the PPD File; Setting up Options

Macintosh
Installing Printer Driver 3 - 13
Setting Up the PPD File
Confirm that the printer is connected to an AppleTalk network before performing the following
procedure.
1
On the [Apple] menu, select [Chooser].
2
Click the [Adobe PS] icon.
3
In the [Select a PostScript Printer:] list, click the name of the printer you want to use.
4
Click [Create].
5
Click the printer you want to use, and then click [Select].
•
The PPD file is set up, and the [Adobe PS] icon appears at the left of the printer name in
the list. Next, make the option settings, or close the [Chooser] dialog box.
Setting Up Options
1
On the [Apple] menu, select [Chooser].
2
Click the [Adobe PS] icon.
3
In the [Select the PostScript Printer:] list, click the name of the printer you want to use,
and then click [Setup].
4
Click [Configure].
•
A list of options appears.
5
Select the option you want to set up and select the appropriate setting for it.
•
If the option you want to set up is not displayed, the PPD file might not be set up
correctly. Check the name of the PPD file shown in the dialog box.
6
Click [OK].
•
The list of options closes.
7
Click [OK].
•
The [Chooser] dialog box appears.
8
Close the [Chooser] dialog box.