Incoming Logins Getting Started
3-6
3.3.1.2 EZWebCon Login and Configuration
EZWebCon enables users on TCP/IP networks to log into and configure the MSS. The
program offers a simple interface that prompts the user for the information necessary to
configure the server. Instructions for installing, running, and using EZWebCon are
included on the CD-ROM.
3.3.1.3 Telnet
To log into the MSS, type telnet followed by the MSS IP address. The MSS must have an
IP address assigned in order for this command to work.
Figure 3-9: A Telnet Connection
3.3.1.4 Rlogin
Rlogin allows users to connect to a remote device as if they were on the local network.
Rlogin is enabled by default.
To log into the MSS, type rlogin followed by the MSS IP address
Figure 3-10: An Rlogin Connection
3.3.2 Incoming LAT Logins
To get an MSS login prompt when connecting from a LAT host, use the command below.
Substitute the last six digits of the MSS hardware address for xxxxxx.
Figure 3-11: LAT Login
3.3.3 Serial Port Logins
Attach a terminal to the serial port and press the Return key. The Local> prompt should
be displayed. Proceed to the Configuration chapter to configure the unit using the
command line interface.
If there was a problem during the boot process, pressing any key will display the Boot
prompt. This prompt enables you to enter a special set of commands, called Boot
Configuration Program (BCP) commands, which are discussed in Appendix B.
% telnet 192.0.1.88
% rlogin 192.0.1.88
$ SET HOST/LAT MSS_xxxxxx
To Next Page
Loading...
Need help?
General