Troubleshooting BCP Command Examples
B-7
Change Software filename
Specifies the name of the file to load. The MSS
will automatically add .SYS to the filename you
specify. Note that all protocols must have a
filename specified (either the default or set by
the user). For more information, see Appendix
D.
TCP/IP users must use the Software option to
specify the loadhost, the loadfile, and their own
network address.
TFTP users can specify a complete path name
(up to 31 characters) if the file is located in a
directory other than the default.The case of the
filename must match that of the filename
loaded onto the host computer.
Show Server
Use this command when issuing other
commands to view the current MSS setup.
To Next Page
Loading...
Need help?
General