Ediz. 010 - 06/2015
GENERAL MAINTENANCE
DAILY
• Clean the lters;
• Clean the nozzles;
• Clean the painting circuit with a suitable product.
PERIODICALLY
• Check the pumping gaskets tightening (if the product draws,
replace the gaskets);
• Clean the mobile parts from the varnish deposits (spray
guns, etc.);
• Check that the tubes and all the ttings are correctly tighte-
ned.
Before performing any maintenance operation,
discharge the pressure in the pumping unit (open
the drain valve).
I
L
ROUTINE MAINTENANCE
CHECK ON THE PACKING NUT
Daily check the packing nut is tight in order to avoid wastes
but not excessively to prevent the piston from seizing and
the gaskets from wearing.
• For tightening, use the wrench supplied (ref. 11503).
• Use the lubricant supplied (ref. 16325) to allow an easy
sliding of the piston inside the gasket group.
Daily top up the packing nut.
ALWAYS DISCONNECT THE POWER SUPPLY
AND RELEASE THE PRESSURE IN THE PUMPING
GROUP (open the drain valve) BEFORE TIGHTE-
NING THE PACKING NUT
.
www.larius.eu
JOLLY
16
Rif. 11503
Adjusting
wrench
Oil ring
OIL
Rif. 16340
To Next Page
Loading...
