DISCONNECT THE POWER SUPPLY BEFORE
CHECKING OR REPLACING THE BRUSHES.
Ediz. 010 - 06/2015
• Periodically check the wear of the brushes (at least every
250 working hours).
• Periodically check the perfect connection among all the
electrical components (at least every 250 working hours).
• The length of the brush contact must be higher than 7 mm
to guarantee a good working of the rotary group.
• To access the brushes proceed as follows: “A - B - C - D
- E”.
ELECTRIC MOTOR
Y
www.larius.eu
JOLLY
43
BRUSHES CHECK
B
C
A
D
E
WARNING: Always indicate code and quantity for each part required.
To Next Page
Loading...
