Explanation
The VISO continuously adjusts itself to the local elevation and displays 0 FT (MT)
in the Altitude/Speed area. If the Altitude/Speed area does not display “0” prior to
jumping, the unit has not yet adjusted itself to the local elevation and it must be
manually zeroed.
To manually zero the unit either perform reset or turn the unit OFF and then ON.
(Perform reset, see page 55)
(Turn OFF the unit, see page 37)
Zeroing the VISO
Note: If the backlight is turned ON while the VISO is not in Jump Mode, the backlight
will automatically turn OFF after 30 minutes, if still not in Jump Mode.
If the backlight is turned ON while the VISO is in Jump Mode, the backlight will
Backlight Setup Area
remain ON until the unit goes out of Jump Mode.
(Jump Mode see page 42)
To Next Page
Loading...
Need help?
General
