LaserPro Venus User Manual

NOTICE
For Firmware (V1.1 and later version), when under the
Single File Mode, the file can be repeated if you choose
to redo it. After the work is completed, the machine
will be back to the “STOP” status. The same file will
be processed again if you press the “START” key again.
One thing that has to take into consideration is that the
file size has to be smaller than 15.9 MB (if memory
buffer for your machine is 16 MB) or 63.9 MB (if the
memory buffer you have is 64 MB). If you choose to
start with a new file, you would have to press the “DEL
FILE” button twice to clear out the memory. Then the
machine will be ready to receive new data again.

LaserPro Venus Specifications

General

Brand	LaserPro
Model	Venus
Category	Cutter
Language	English

Summary

UNPACKING

QUICK MENU

LENS and MANUAL FOCUS GAUGE

INTRODUCTION

Principles of CO2 Laser

Explains the fundamental working principle of a CO2 laser system.

Safety

Details safety ratings, precautions, and necessary safety measures.

Front View

Identifies and labels the key components visible on the front of the machine.

Back View

Identifies and labels the key components visible on the back of the machine.

Motion System

Describes the mechanical components that enable the machine's movement.

RECOMMENDED CONFIGURATION

Computer

Specifies the required PC hardware and operating system for optimal use.

Scanner

Lists the minimum resolution requirements for a compatible scanner.

Software

Outlines the necessary software and driver versions for operation.

HARDWARE INSTALLATION

Cabling Connection

Provides step-by-step instructions for connecting power and interface cables.

Exhaust Vent

Instructions on how to properly connect the machine's exhaust system.

SOFTWARE INSTALLATION

OPERATION

Environment

Specifies the ideal operating environment, including temperature and humidity.

Flexible Utility of Your Memory Buffer

Explains the machine's memory buffer capabilities and modes.

Multiple File Mode / Single File Mode

Details the differences and usage of Single file and Multiple file modes.

Start to Operate

A guide on the procedures to begin operating the machine.

Control Panel

Describes the buttons and functions of the machine's control panel.

BASIC MAINTENANCE

Clean the mirror

Provides instructions on how to clean the machine's mirrors and lenses.

TROUBLE SHOOTING

Quality Problems

Lists common issues affecting the quality of engraved or cut output.

Non-operational Problems

Addresses problems preventing the machine from functioning or starting.

APPENDIX

Specification

Presents detailed technical specifications of the LaserPro Venus.

Tip for 3D Application

Offers guidance and parameters for successful 3D engraving tasks.