LaserPro Venus - Page 35

35
NOTE:
** means default or current setting.
! Set data bit/parity?
Data bits refer to the size of one block of data and parity is used to check if data
was received correctly or not. The data/parity feature is to adjust the byte format
and parity type in order to communicate with the host computer.
8 bits no parity **
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
8 bits even parity
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
Set data bit/parity?
Ok: ENTER
End operation: Esc
Select language? :
△
△△
△ or ▽
▽▽
▽
ENTER
Select language?
Yes: ENTER
End operation: Esc
ENTER