LaserPro Venus - Page 37

37
! Enable/Disable auto focus
The manufactures’ default is Auto-focus enable. If auto-focus set as disable, the
working table will not lower down automatically as soon as power turned on.
Set data bit/parity?
Yes: ENTER
End operation: ESC
Set autofocusing? :
Set autofocusing?
Yes: ENTER
End operation: Esc
Select language ? :
ENTER
Enable **
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
Disable
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
△
△△
△ or ▽
▽▽
▽