5
NOTE:
! If the memory buffer is set up in Single file mode, under START condition,
the engraver will start to engrave/cut upon receiving a file. While if the
memory buffer is set up in Multiple File mode, receiving at least one
complete file then press START/STOP to start a job (refer to page 14, Start
to Operate).
! Choices of DPI must be the same for both editing and printing out a file.
! Turn on the air exhausting system before engraving.
! The maximum loading weight of working table is 5 kg.
! When engraving at 3D mode or cutting materials that easily caught on fire,
such as acrylic, wood or paper, it is advised to have air compressor turned
on to prevent flame.
To Next Page
Loading...