Initial Set-Up
Parking Brake
3
3-2 Lastec Mower 3372/011305 Initial Set-Up
3.1 Parking Brake
WARNING!
ALWAYS set the parking brake before performing any set-up, inspection, adjust-
ments, or maintenance to the Lastec Mower!
ALWAYS release the parking brake before operating the Lastec Mower!
The parking brake is located to the left of the operator seat, just in front of the left steering control
arm. To set the parking brake, grasp the handle and pull upward, increasing the brake tension,
until the tension prevents any further travel of the handle.
To release the parking brake, pull upward on the handle to relieve the brake tension, and slowly
return the handle all the way down to its original position.
Brake tension can be adjusted by loosening or tightening the nut under the left side of the frame
rail.
Warning
Parking Brake
Go to www.lastec.com for latest changes in this manual.
To Next Page
Loading...
