Initial Set-Up
Maintenance Checklists
Initial Set-Up Lastec Mower 3372/011305 3-18
3
3.25 Maintenance Checklists
Complete the appropriate maintenance checklists in a timely manner. (See section 5).
3.26 Pre-Operation Equipment Inspection Checklist
Perform the following equipment inspection prior to each operation of the Lastec Mower:
Verify that the parking brake is set.
Check the fuel level.
Verify that the fuel shut-off valve (behind and right of the operator) is in the Left or Right position.
Check engine oil level and condition.
Check the air cleaner and filter elements for contamination or debris.
Brush out and clean the radiator screen.
Check coolant level and condition in overflow tank.
Check hydraulic fluid level and condition. Add if low - do not overfill. Change oil and filter if necessary.
Inspect the entire hydraulic system for leaks.
Adjust hydrostatic pumps if needed.
Check both hydrostatic pump belts and tension springs for proper installation, tension and condition.
Check the mower deck drive belt and idler tension spring for proper installation, tension and condition.
Clean entire mower deck area under operator seat pan of any grease, oil, fuel, grass, or debris.
Check all mower deck belts and idler tension springs for proper installation, tension, and condition.
Clean each deck of any grease, oil, fuel, grass, or debris.
Inspect all blades for proper installation, orientation, tightness, sharpness, and overall condition.
Be sure the seatbelt is secure and operable.
Adjust the operator seat for proper operator position.
Check that both steering controls arms are properly linked, free of debris, and operating freely.
Set the mower deck height to the desired level.
Calibrate the mower deck height adjustment rods if needed.
Check the air pressure in the rear drive tires.
Verify proper function of all wheels.
Verify that all warning decals are in place, visible and legible.
Verify that all covers and safety devices are properly installed and secure.
Check that the discharge chute is clear of debris, properly mounted, and in good condition.
Inspect entire Lastec Mower for loose or entangled parts, debris, obstructions, or neglected tools.
Verify that the battery has sufficient charge to start the engine.
Check engine for abnormal exhaust or sounds.
Be sure the operator seat pan and engine cover are properly closed, latched, and secure.
Record the hour meter setting if desired.
Complete the appropriate maintenance checklist (section 5).
Go to www.lastec.com for latest changes in this manual.
To Next Page
Loading...
