Initial Set-Up
Engine Oil
Initial Set-Up Lastec Mower 3372/011305 3-5
3
3.5 Engine Oil
WARNING!
ALWAYS turn off engine before checking the oil level, changing the oil, or changing
the oil filter!
ENGINE OIL IS HOT! ALWAYS allow ample time for oil to cool before changing or
repairing leaks!
CAUTION!
Be sure to use the correct oil in the engine crankcase!
Be sure to check the engine oil level and quality daily!
Incorrect oil, inadequate oil level, or contaminated oil will cause engine damage!
It is important that the proper type of oil be used in the crankcase. It is also important that the oil
level and quality be checked daily. Use of incorrect oil, inadequate oil level, or contaminated oil will
cause engine damage.
Be sure the Lastec Mower is parked on level ground before checking the oil level. Always check
the oil level before starting the engine, or wait more than five minutes after turning off an engine
that has been running. Check the oil level with the dipstick located under the air cleaner, behind
the radiator overflow bottle. To add or change the engine oil and/or oil filter, allow ample time for
the engine and engine oil to cool. Consult the Kubota Diesel Engine Operator’s Manual for the
proper procedures.
When operating in temperatures ranging from 32° - 77°F (0° - 25°C), engine oil should be
MIL-L-2104C or have properties of API classification CD/CE grades, with an SAE viscosity grade
of 10W-30. Due to the nature of the lawn care industry, it is assumed that operation of the Lastec
Mower will typically be in air temperatures within the above listed range. If you will be operating the
Lastec Mower in air temperatures outside this range, consult the Kubota Diesel Engine Operator’s
Manual for the proper SAE viscosity grade of oil that should be used.
3.6 Air Cleaner
The air cleaner is located under the engine cover, to the top
right of the engine. There are two filter elements within the
air cleaner. The cap (located on the rear of the air cleaner) is
opened by unlatching both silver latches located on the sides
of the filter housing. Check that both filter elements are clean
and free of debris. Clean or replace if necessary. Consult the
Kubota Diesel Engine Operator’s Manual for the proper
procedures.
To Next Page
Loading...
