Operating Procedures
Stopping The Engine
Operating Procedures Lastec Mower 3372/011305 4-3
4
2. Turn the key switch clockwise to START position, cranking the engine for a maximum of
10 seconds.
NOTE: Cranking engine for more than 20 seconds will cause electrical failure!
3. If the engine does not start within 10 seconds, discontinue cranking by turning the key
switch counter-clockwise to the OFF position. Wait 60 seconds. Repeat steps 1 through
3. If, after several attempts, the engine will still not start, discontinue the starting process
until the cause of malfunction is determined.
4. When the engine starts, adjust the throttle lever (located to the right of the operator seat,
with the deck height adjust handle) forward until the engine is running at a steady idle. Do
not overpower the engine.
4.2 Stopping The Engine
Stop the engine by throttling down to a slow idle, then turning the ignition key switch to the OFF
position. Wait for all motion to stop. Set the parking brake before dismounting the Lastec Mower.
4.3 Motion Control
WARNING!
ALWAYS clear the entire area of all personnel before operating the Lastec Mower!
ALWAYS verify that all safety covers are in place and secure before operating the
Lastec Mower!
ALWAYS wear the seatbelt when operating the Lastec Mower!
The Lastec Mower 3372 is equipped with two hydrostatic pumps, one operating each rear drive
wheel. These pumps are controlled separately with each of the steering control arms (located to
the left and right of the operator seat).
Verify that all safety covers are in place and secure before operating the Lastec Mower. Buckle the
seatbelt. Always wear the seatbelt when operating the Lastec Mower. Clear the entire area of
all personnel before operating the Lastec Mower.
Start the engine in accordance with section 4.1 of this manual.
Pushing a steering control arm forward activates the hydrostatic pump on the corresponding side,
turning the drive wheel in the corresponding direction. (i.e., pushing the right steering control arm
forward activates the right drive wheel in the forward direction. Pulling the right steering control
arm back activates the right drive wheel in the reverse direction.)
Warning
Go to www.lastec.com for latest changes in this manual.
To Next Page
Loading...
