Lastec Articulator - Pre-Operation Equipment Inspection Checklist

Initial Set-Up
Pre-Operation Equipment Inspection Checklist
Initial Set-Up XR700 062419 3-15
3
3.13 Pre-Operation Equipment Inspection Checklist
Perform the following equipment inspection prior to each operation of the Articulator.
 With the tractor and Articulator parked on level ground, verify that the Articulator is properly mounted
to the tractor and secure.
 Verify that the PTO shaft is properly mounted and secure, and the PTO shaft cover retaining chains
are secure.
 Check the oil level in the gearbox.
 Inspect area around and under the gearbox for any oil leakage.
 Set the deck height to the desired level. If necessary, calibrate the rear deck height chains.
 Check the deck drive belt and idler tension spring for proper installation, tension and condition.
 Clean the entire center deck area (including under the belt cover) of all grease, oil, fuel, grass, or
debris. Ensure to replace all covers, shields, and guards.
 Check all deck belts for proper tension.
 Align front decks 1, 2 and 3.
 Align outer decks 6 & 7.
 Clean each entire deck area (including under the belt covers) of all grease, oil, fuel, grass, or debris.
Ensure to replace all covers, shields, and guards.
 Inspect all blades for proper installation, orientation, tightness, sharpness, and overall condition.
 Verify proper function of all gauge wheels.
 Verify that all warning decals are in place, visible and legible.
 Verify that all covers and safety devices are properly installed and secure.
 Check that the discharge chute is clear of debris, properly mounted, and in good condition.
 Inspect entire Articulator for loose or entangled parts, debris, obstructions, or neglected tools.
 Perform all safety, set-up, and pre-operation procedures listed in your tractor manual.
 Complete the appropriate maintenance checklist (section 5).