Every 8 Hrs
Every 50 Hrs
Every 200 Hrs
Every 500 Hrs
Annual
Complete the Pre-Operation Equipment Inspection Checklist
●
●
●
●
●
Grease All Grease Zerks
●
●
●
●
●
Grease All Wheel Hubs
●
●
●
●
●
Grease PTO Shaft Collar & Both Cross Bearings
●
●
●
●
●
Inspect All Blade Spindle Bearings Grease Seals for Grease Leakage or Improper Seating
●
●
●
●
●
Verify that all hardware is is properly installed and functioning
●
●
●
●
●
Lubricate All Joints & Moving Parts Not Equipped With Grease Zerks
●
●
●
●
●
Inspect Articulator for Loose or Entangled Parts, Debris, Obstructions, Neglected Tools or Other Hazards
●
●
●
●
●
Perform the Appropriate Maintenance Procedures Listed In Your Tractor Manual
●
●
●
●
●
Verify grass chutes cleared
●
●
●
●
●
Clean, lube, retighten all guide wheels
*
●
●
●
●
Lubricate the PTO Quick-Disconnect Pin or Twist Sleeve
●
●
●
●
Check deck alignment and belt tension
●
●
●
●
Check drive belt alignment
●
●
●
●
Inspect gearbox pivot stops, wearpads, and bushings
●
●
●
●
Clean off any debris that has accumulated
●
●
●
●
Inspect gearbox and seals fopr leaks
●
●
●
Grease All Blade Spindle Bearing Housings
●
●
●
Inspect All Bushings
●
●
●
Check gearbox condition and lube/fill as needed
●
●
●
Change the Gearbox Oil with 80W90
**
●
●
Inspect All Blade Spindle Bearings for Wear, Damage, Debris, & Proper Installation
●
●
Re-pack All Wheel Bearings
●
●
Inspect All Component Parts And Wear Points
●
●
Install the 040220 Model 721XR Articulator Rebuild Kit
●
Replace gearbox shaft seals
●
* First 8 hours, then every 50 after that.
** First 50 hours, then every 200 afer that.
To Previous Page
Loading...
