Lastec Articulator - First 8 Hours; Every 50 Operating Hours

Maintenance
First 8 Hours
Maintenance XR700 062419 5-5
5
 Lubricate all joints and moving parts which are not equipped with grease fittings.
(Recommend the use a nickel-based anti-seize for these areas).
 Inspect entire Articulator for loose or entangled parts, debris, obstructions, mis-
placed tools, or any other possible safety hazards, equipment hazards or projectile
hazards. Clean off decks of any dirt, grease or oil.
 Clean and gauge wheels to reset the bearing pre-loads such that spindles are loose
enough to spin freely only one complete revolution when spun by hand; ensure
spacers are properly installed.
 Perform the appropriate maintenance procedures listed in your tractor manual.
 Verify proper installation, operation and flow of grass chutes.
5.5 First 8 Hours
 Check deck alignment and belt tension.
 Lubricate the PTO quick-disconnect pin or twist sleeve. (Recommend the use a
nickel-based anti-seize for these areas).
5.6 First 50 Hours
 Change gearbox lube with 80W90 gear oil.
5.7 Every 50 Operating Hours
 Check deck alignment and belt tension.
 Check deck drive belt alignment.
 Grease all blade spindle bearing housings. Fill until grease purges from the weep
hole in the side of the bearing housing.
 Inspect all bushings for wear. Replace as needed.
 Inspect gearbox pivot stop bolts, wear pad, and bushings. Replace or adjust as
needed.
 Check and clean, if necessary, any debris that may have accumulated during
operation.
 Check gearbox lube level and condition.