Initial Set-Up
Engine Oil
3-3 9/27/19 Initial Set-Up
3
2. Clean the entire engine area and mower deck area (under the operator seat pan) of all
excess grease, oil, fuel, grass, or debris before operating your Articulator to prevent dam-
age to the equipment, fire hazard, and projectile hazards.
3. Ensure the operator seat pan is properly closed before operating or engine will not start.
3.5 Engine Oil
Turn off engine before checking the oil level, changing the oil, or
changing the oil filter and allow ample
time for oil to cool before chang-
ing or repairing leaks.
Ensure to use the correct oil in the engine crankcase.
Ensure to check the engine oil level and quality daily.
Incorrect oil, inadequate oil level, or contaminated oil will cause
engine
damage.
Ensure your Articulator is parked on level ground before checking the oil level.
Check the oil level when engine is cool -- before starting the engine, or more than five
minutes after turning the engine off.
To add or change the engine oil and/or oil filter, allow ample time for the engine and
engine oil to cool. Consult the Engine Operator’s Manual for the proper procedures.
Consult the Engine Operator’s Manual for the proper SAE viscosity grade of oil that
should be used depending on your operating conditions.
3.6 Air Cleaner
The air cleaner is located on top off the engine.
There are two filter elements within the air cleaner.
1. Open by unlatching the filter housing.
2. Check that both filter elements are clean and free of debris.
To Next Page
Loading...
