Lathem PC700 - Page 35

Troubleshooting the PC700 Series Clock • 31
The clock shows “Not Found”
when a badge is presented.
Make sure that the number that
is printed on the badge matches
what was entered in the Badge
Number field in PayClock for the
employee.
A blinking light shows in the
small rectangular opening to the
left of the illuminated oval on the
front of the clock. What does it
mean?
This blinking light represents the
wired connection to the network
(LAN). If the light is not blinking
there isn’t a connection to the
network (LAN).
What are the green bars on
the display representing?
This represents the WiFi signal
strength.
What are the double green
arrows
on the display
representing?
This represents that the clock is
connected to the internet and
PayClock Online.
Why does the clock show “Punch
Accepted” instead of Punch In or
Out when an employee
punches?
The clock lost the connection to
the internet, so it displays Punch
Accepted. The clock must have a
connection to the internet to
determine if a punch is In or Out.
Check to see if the arrow
icon
is displaying at the top of the
screen.
How do I disable the idle screen
on the clock?
While the idle screen doesn’t
affect the operation of the clock
some users may wish to disable
the feature. To disable the idle
screen, press the Admin button
and enter 528436 then press
Enter. Press OK to the
confirmation message “Idle
Screen Mode: Off”. Note: to
reactivate the idle screen simply
enter the 528436 code again.