Appendix D - Add/Edit/Delete Bell Events • 41
Appendix D -
Add/Edit/Delete Bell
Events
Up to 100 events can be programmed. Events consist of the time
and the day of week the event will activate the relay.
Adding a Bell Event
• From the PC700 touchpad press the Admin button. Enter the
administrator PIN and press Enter.
• From the Administrator Main Menu press Relay Settings.
• The Relay Settings screen will display.
• Press Signal under the Mode Settings. The button will
change to blue identifying it’s enabled.
• Press Schedule under Signal Events. The Signal Event
Schedule screen will display.
• Press +Event. The Edit Event screen will display.
• Using the up and down arrow keys select the desired hour,
minute and AM/PM for the bell event.
• Press the buttons for the desired days of the week, a check
will display in the box identifying the day is selected.
• Press OK to save the event. The programmed event will
display in the list.
• Continue adding the desired events.
• When finished press the back button until you have
returned to the home screen.
To Next Page
Loading...
