Lauda INTEGRAL XT - 8. Service; 8.1 Displaying device data; 8.2 Contact address

Flow controller MID 20
23
8. Service
8.1 Displaying device data
For service or diagnostic purposes, you can use the command remote control unit of the Integral XT
to view device data for the additional pump.
This only applies for the flow controller with a higher-pressure pump.
Input for service menu
1. Press the “Menu” soft key.
2. Use the “up” and “down” arrow buttons to move the cursor to the “Settings” menu item and
press “Enter” or the “right” arrow button to confirm.
3. Use the “up” and “down” arrow buttons to move the cursor to the “Device status” menu item
and press “Enter” or the “right” arrow button to confirm.
4. Use the “up” and “down” arrow buttons to move the cursor to the “Device data” menu item and
press “Enter” or the “right” arrow button to confirm.
5. Use the “up” and “down” arrow buttons to move the cursor to the “Display” menu item and
press “Enter” or the “right” arrow button to confirm.
Device data
Description
P2 power
Power of pump 2 in watts
Pump rpm
Pump speed in rpm
Pump current
Current consumption in amperes
Pump voltage
Voltage in volts
Temp. pump
Reference temperature of pump in °C. The value should not exceed 100 °C.
8.2 Contact address
Contact LAUDA Service in the following cases:
 In the event of faults on the device
 For technical questions about the device
 For spare part orders
LAUDA Service
Telephone: +49 (0)9343 503 350
Fax: +49 (0)9343 503 283
Email: service@lauda.de
If you have application-specific questions, please contact your responsible LAUDA sales employee.