6
1.2 General safety instructions
Read this operating manual carefully. It contains important information about how to handle this device. In
addition to these operating instructions, the operating instructions of the main device Integral XT are also to
be given full consideration. If you have any questions, please contact the LAUDA service department
( chapter 8.2).
Follow all instructions in this operating manual. That is the only way to ensure that you handle the device
correctly.
Ensure that the device is only operated by trained personnel ( chapter 2.4).
The device may not be operated without heat transfer liquid.
Use suitable protective equipment when working on the device or connected components.
Use the integrated bypass to ensure that there is a constant flow rate of heat transfer liquid
( chapter 5.2.5).
Never operate the device if:
- Damage has been ascertained on device components or
- the device is leaking.
Switch off the device and unplug the mains plug:
- for service and repair work,
- when moving the device,
- if there is danger.
Do not make technical changes to the device. In the case of infringement, any warranty claim is void.
Only allow service and repair work to be performed by specialists.
Addition for devices with an additional pump:
The additional pump may not have fluid flowing through it when at a standstill, as this may
damage the pump.
The additional pump, together with the process thermostat from the LAUDA XT series, is a
system requiring monitoring in accordance with §14 of the German Industrial Health and Safety
Ordinance¹. (Classification in accordance with Pressure Equipment Directive 97/23/EC: Category I). Before
commissioning, the system must be subjected to an inspection of the installation, order and functions by
qualified personnel ( chapter 2.4) Certification of this inspection shall be created, documenting the scope
and result of the inspections.
¹ The national regulations of the country in which the system is set up must be followed.
To Next Page
Loading...