EasyManua.ls Logo

Lauda INTEGRAL XT - 2.4 Personnel qualification; 2.5 Owners responsibility; 2.6 EC conformity

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Flow controller MID 20
8
2.4 Personnel qualification
Operating personnel
Operating personnel are personnel who have been instructed by specialist personnel about the intended
use of the device according to the operating manual, about the hazards posed by the heat transfer liquid,
about the working temperature ranges and the pressures within the application as well as the necessary
protective measures.
Specialist personnel
Specific activities on the device must be carried out by technical staff. Technical staff is personnel that can
evaluate functions and risks of the device and the application based on their training, skills and experience.
Typically, this personnel has had appropriate training or third-level education in a relevant technical area.
Specialist personnel must be able to judge the hazard posed by the heat transfer liquid, the working
temperature ranges and the pressures within the application and to determine the necessary protective
measures and the effectiveness thereof.
2.5 Owner's responsibility
The owner is responsible for the qualification of the specialist and operating personnel.
The thermostat may only be configured, installed, maintained and repaired by specialist personnel.
Persons who operate the device must have been instructed in their duties by specialist personnel.
Ensure that specialist personnel and operators have read and understood the operating instructions.
The device is to be used in the intended manner ( chapter 2.2).
2.6 EC conformity
The device complies with the applicable basic occupational health and safety
requirements of the Directives listed below:
Manufacturer
LAUDA DR. R. WOBSER GMBH & CO. KG
Laudaplatz 1
97922 Lauda-Königshofen
Germany
Low Voltage Directive 2014/35/EU
EMC Directive 2004/108/EC
Safety requirements for electrical equipment
for measurement, control and laboratory use
DIN EN 61010-1