LAUMAS LCB - Zero Parameters; Resettable Weight Setting for Small Weight Changes; Automatic Zero Setting at Power-On

- 17 -
COMMUNICATION INTERFACE
WRITING
READING
 Write the enabling status* in W1.
 Send command 6128 to CMDR.
 Send command 6127 to CMDR.
 Read the enabling status* in R1.
*1= enabled; 0= disabled
ZERO PARAMETERS
RESETTABLE WEIGHT SETTING FOR SMALL WEIGHT CHANGES
 (from 0 to full scale; default: 300; considered decimals: 300 – 30.0 – 3.00 – 0.300): this
parameter indicates the maximum weight value resettable by external contact, keyboard or serial
protocol.
COMMUNICATION INTERFACE
WRITING
READING
 Write the value in W1.
 Send command 6102 to CMDR.
 Send command 6101 to CMDR.
 Read the value in R1.
AUTOMATIC ZERO SETTING AT POWER-ON
 (from 0 to 10% of full scale; default: 0): if at switch-on the weight value is lower than the
value set in this parameter, the weight is reset. To disable this function, set 0.
COMMUNICATION INTERFACE
WRITING
READING
 Write the value in W1.
 Send command 6028 to CMDR.
 Send command 6027 to CMDR.
 Read the value in R1.








