Launch Creader 629 - Page 33

LAUNCH 629 User's Manual
28
www.x431.com +86 755 8455 7891
Note: In case the diagnosc codes are manufacturer-specic, users need to
select the manufacturer manually and the following prompt message will pop up
on the screen.
Figure 5-4
Press [OK] to enter to select the manufacturer. Figure 5-5 will be shown on the
screen.
Figure 5-5
Press
[ ] / [ ]
to select dierent manufacturer; press the
[ ] / [ ]
buon to turn
to next or previous page. Aer selecng the desired one, press [OK] to conrm.
• If some DTCs are found, the screen will display the DTCs (Refer to Figure 5-3).
• If the DTC can not be found, a screen similar to the following gure will appear: