Launch X-431 V+ User Manual

LAUNCH X-431 V+ V4.0 User Manual
83
1. For initial use, you are suggested to reset the printer: Press and hold [MODE]
& [FEED] for 8 seconds, the following resetting command will be printed out:
at + default = 1
ok
at + reboot = 1
rebooting...
2. Tap
Reset
to configure Wi-Fi printer.
Step 1: Connect the printer:
Tap
Scan
to start scanning and select the desired printer hotspot named with
X-431PRINTER-XXXX (XXXX stands for 4 characters), and then tap
Connect
to enter Step 2.
Step 2: Join the Wi-Fi printer into LAN:
Tap
Scan
to select the desired local Wi-Fi network from the list, and type in
the security password (If it is an open network, password is not required), and
then tap
Confirm
.
3. Once the Wi-Fi network of the printer is connected and the printer is found,
tap
Printing test
to test the printing.
Now the Wi-Fi printer is ready for printing.
If the printer is not found, please reset the printer to default factory settings (refer
to Step 2 for details) and check whether the current device and the printer are on
the same LAN.
B. If you have configured the Wi-Fi printer to the LAN:
2. Tap
Connect to Printer
:
a). If the local network remains as it is, tap
Test Print
directly to test the
printing.
b). If the local network changes, you have to reset the Wi-Fi printer.
For other Wi-Fi printers
,
Before printing, make sure the following conditions are met:
• The Wi-Fi printer is powered on and working normally.
• The print service plug-in associated with the printer is already installed on the
tablet (Go to Google Play or use the Browser to download and install it).

Launch X-431 V+ Specifications

General

Screen Resolution	1280 x 800 pixels
Connectivity	Wi-Fi, Bluetooth
Operating System	Android
Display	Touchscreen
Battery	7000 mAh
Camera	5MP
Supported Protocols	OBD II, EOBD, CAN, etc.
Languages	Multiple languages