posed and disposed of according to the waste col-
lection and disposal regulation in force.
5.2. Positioning
For a correct ergonomic use of the machine, place it on
a stable and perfectly horizontal surface, away from
water source, flames and heat. The area should be suf-
ficiently illuminated, ventilated, hygienic, not corrosive
and/or explosive and equipped with a power outlet rea-
dily reached with the supplied power cord. Also make
sure that the place where the machine is installed has di-
mensions and sturdiness suitable to safely support it.
For the correct operation of the machine the following
advice is given:
- room temperature: 10°C ÷ 25°C;
- maximum humidity: 65%.
Warning
The machine is not suitable for outdoor installation,
and should not be exposed to weather.
Warning
The presence of magnetic fields or proximity of elec-
tric machines which generate disturbances, may
cause malfunctions in the electronic control of the
machine.
Warning
With temperatures approaching 0°C there is the risk
of freezing internal parts of the machine which con-
tain water. Do not use the machine under these con-
ditions.
Attention
Sufficient space must be allowed to access the ma-
chine and the plug, to allow the user to move freely
and to be able to immediately leave the area in an
emergency.
Prepare a support base that is suitable to support its
weight (1); It is important that all the terminal connec-
tions to the water (2) and electrical mains (7) are easily
reachable and, in any case, close to the machine.
It is recommended to equip the working base of the ma-
c
hine with a drawer (10) to collect the used coffee cap-
sules.
Attention
For correct operation, the machine must rest on a
perfectly horizontal surface. Any alignment adju-
stments of the machine must be done by adjusting
feet (5).
5.3. Water connection
Warning
Inlet and outlet water connections should comply
with applicable laws in force in the country where
the machine is used.
Connect the water mains (2) to the inlet which is on the
back of the machine (6) using the flexible pipe provided.
Then open the water mains valve.
Connect the drain tray of the machine (4) to the sewer
drain (3) using the special pipe provided. Take care to
avoid tight bends or kinks and keeping a sufficient incli-
nation for drain water evacuation.
To Next Page
Loading...
