Leb Electronics CTR57 - Maintenance; Conformity Declaration; Programming the Board; Remote Control Codes Self-Learning

24
ENGLISH
E) MAINTENANCE
Warning : The maintenance of the device must be effected only and exclusively by a specialized technician authorized from the Manufacturer.
Any operation of maintenance or control of the device must be effected in absence of power supply.
Ordinary maintenance: Every time that it is necessary and however every 6 months is recommended to verify the device operation.
Extraordinary maintenance: In case of failure, remove the device and send it for repair to the manufacturer laboratory or to authorized laboratory.
The Manufacturer is not responsible for missing observance of rules above described.
F) CONFORMITY DECLARATION
Description of the device : Electronic board for the control of 1 or 2 low voltage 12 / 24Vdc motors for the automation of a swing gate
Model : CTR57
Rules applied : EN 61000-6-3, EN 61000-6-1, EN 301489-1, EN 301489-3, EN 300220-2, EN 300220-1, EN 60950-1
Test laboratory : NEMKO SPA
Outcome : Positive
The manufacturer declares that the above listed products comply to the norms provided for by directives 2004/108/EC and 2006/95/EC.
Date , 04-01-2012
G) Programming the board
Warning : before proceeding with the programming of the card, it is necessary that all the inputs are connected correctly (see chapters D1
and D2). Attention: with the gate positioned at the half of run, the first command after a power off always determines an opening.
If not, reverse the connection of the motor on the terminal board (clamps 11-14 on terminal board J1).
Remote control codes self-learning
Press the P1 key once to insert a “Start” code; press the P1 key twice to insert a “Pedestrian Start” code. Each time the push-button is pressed, the
led DL1 flashes in acknowledgement. Subsequent pressures of the P1 key must be spaced by 1 sec. minimum periods. When the led is lit with a fixed
light transmit the code to be learn by means of the remote control.
Erasing all stored codes
Keep pressed the P1 key until the led DL1 goes off (about 10 seconds).
Programming the works times
1) Automatic setting - 1 and 2 wings gate
Make sure the gate is completely opened. If not, position it manually. Rotate the trimmer RV1 at the minimum in counter-clockwise sense and then
press once the key P2. After a few seconds the gate will perform a series of operations which will allow the equipment to automatically learn the work
times.
Attention : during the operations of the work times auto-learning all the safety devices are ignored.