27
ENGLISH
I)
QUICK START GUIDE
INSTALLATION STEP BY STEP - FAST OPERATION
Once carried out the connections, go ahead with the following procedure:
1. Single wing gate: Make sure that the operator is connected to the terminals 13-14 (M2) of the terminal board J1.
2-Wings gate: Make sure that the operator, first in opening, is connected to the terminals 13-14 (M2) of the terminal board J1.
2. Connect the Mains power 230Vac to the device;
3. Insert at least 1 remote control (see pag. 24);
4. Checking the polarity of the motors’ connections: Manually unblock each operator and place the gate at the half of the run. Block
each operator. Press the key of the remote control in order to send a Start command. The first command after a power off always
determines an opening. if not, reverse the connection of the motors on the terminals 11-12-13-14 of the terminal board J1;
5. If the gate don’t move, check the connection of the photocell, led DL2 must be on, the electric contact must be NC (normally
closed) and try again;
6. It is possible to choose the manual or automatic programming, applying one of the following procedures:
AUTOMATIC PROGRAMMING
a. Unblock each operator and place the gate at the complete opening. Block each operator and adjust the Trimmer RV1 at the minimum
in counter-clockwise sense.
b. Press the key P2.
After a few seconds the gate will perform a series of operations which will allow the equipment to automatically learn the
work times.
c. End of programming
MANUAL PROGRAMMING
a. Unblock each operator and place the gate at the complete closing. Block each operator.
b. See the instructions at page 12 - par.2 up to the end of programming.
7. Set up the logic of operation (step by step, automatic or condominium), pause time and slow down speed (RV1) as indicated in this
manual at page 25.
To Next Page
Loading...