21
ENGLISH
Blinker
The electronic card supplies an on/off control (flashing light) to the lamp. The logic of the blinking allows displaying the gate’s operating.
Quick flashing light : it signals the opening phase
Slow flashing light : it signals the closing phase
A flash every three seconds: it signals the opening and closing phase in absence of power supply 230Vac.
Fixed light : it signals that the gate is blocked in wait that the obstacle that covers the photocell to be removed.
The device supplies an on/off control (flashing light) to the lamp for approx. 1 sec. before the motors start (pre-alarm).
M1 delay at opening
The unit causes a fixed delay of approx. 2 seconds between the first wing’s (M2) and the second wing’s (M1) start during the gate’s opening phase.
This delay is imposed irrespective of the position from which the gate starts to open.
n case of absence of power supply, with the backup Battery connected to the card, the blinker flashes every 4 sec. (in opening and closing cycle).
12) Operation modes
Introduction
The electronic unit contains a micro-processor to control the gate’s operation modes. These are the four main operation phases:
- Phase preceding the gate’s motion
- Gate’s fast motion phase
- Gate’s slow motion phase
- Gate’s pause phase (open gate)
The unit can function in three modes:
Step by step – This mode is enabled by setting the Pause time to “0” , see the chapter “Pause time setting”
Automatic – This mode is enabled by setting the Pause time by means of P3 and P2 keys , see the chapter “Pause time setting”
Condominium– This mode is enabled by setting the Pause time by means of P3 and P3 keys , see the chapter “Pause time setting”
Notice: The operation logic setting, the work time programming and the pause time programming must be carried out only if the cycle is concluded or
before it starts (with closed gate).
The opening and closure cycles are enabled by a Start or Pedestrian start control.
Important : Whatever logic has been selected, the first Start command after the power is supplied to the electronic card will always cause the start of
an opening cycle.
To Next Page
Loading...