23
ENGLISH
13) Electrical and mechanical specifications
Dimensions and weight (with plastic box) : 186 x 283 x 112 mm - 2,3 Kg
Power supply transformer : 230/12-20Vac - 100VA
Battery-charger capacity : 0,1A max
Optional battery capacity : 12V–7Ah or 24V-4Ah
Blinker power supply : 12V or 24V - 15W max
Relays contacts capacity : 15A max
Motor power supply : 12Vdc or 24Vdc - 100W max (total)
Accessories power supply : 12Vdc - 3 W max
Operating temperature range : 0 to + 60 °C (internal)
Motors’ work time : programmable, 1 to 120 sec.
Pause time : programmable, 1 to 120 sec.
2
nd
wing closing delay : programmable, 0 to 120 sec.
Amperometric Stop : Automatic
Caution : The unit must be not switched on if the connected loads or the power supply exceed the a.m. limits. Failure to observe this precaution can
result in damage to persons, animals or objects for which the manufacturer cannot be held responsible.
14) Electric connections
3 electric connectors are fitted to the card :
1) J1 14-pole removable terminal board for the connection of the power devices, commands and safety devices
2) FS1,FS2 nr. 2 Faston terminal for the connection of the power supply transformer
3) FS3,FS4 nr. 2 Faston terminal for the connection of battery. Warning: respect the polarities (see page 26) and the voltage (see JP1)
Terminal board J1
Terminal1 - Aerial cable connection (signal)
Terminal2 - Aerial cable connection (shield)
Terminal3 - Start push-button’s normally open electric contact
Terminal4 - Common
Terminal5 - Photo-cell’s normally closed electric contact
Terminal6 - Common
Terminal7 - Positive power supply for photo-cell and/or other devices
Terminal8 - Negative power supply for photo-cell and/or other devices
Terminal9 - Power supply for blinker
Terminal10 - Power supply for blinker
Terminal11 - Motor M1 power supply
Terminal12 - Motor M1 power supply
Terminal13 - Motor M2 power supply
Terminal14 - Motor M2 power supply
To Next Page
Loading...