Lectra Alys 30 - 3. Minimum required configuration; 3.1 Hardware configuration; 3.2 Software configuration

1MRMQYQVIUYMVIHGSRJMKYVEXMSR 
%% %P]WQEMRXIRERGIQERYEP
 1MRMQYQVIUYMVIHGSRJMKYVEXMSR
 ,EVH[EVIGSRJMKYVEXMSR
The Alys plotter requires a single-phase mains supply of 115V or 230V 50/
60Hz.
It is controlled by a PC that has had control software installed during the
installation of the plotter.
- Pentium PII 300 Mhz
- 128 Mb of memory
- 1 parallel port to connect to the plotter
or
- 1 USB port (Windows 2000 only)
or
- 1 RS232 serial port
!
<RXPXVWUHVSHFWWKHUHFRPPHQGHGFDEOHOHQJWKVWRFRQQHFWWKH
SORWWHUWRLWVRSHUDWLQJ3&/HFWUD6\WÅPHVFDQQRWJXDUDQWHHFRUUHFW
$O\VSORWWHUIXQFWLRQLQJLIDFRQQHFWLRQFDEOHORQJHUWKDQWKDW
LQGLFDWHGEHORZLVXVHG
&HQWURQLFVSDUDOOHOPHWHUVPD[LPXP
86%QRUHSHDWHUPHWHUVPD[LPXP
56VHULDOPHWHUVPD[LPXP
 7SJX[EVIGSRJMKYVEXMSR
Minimum software configuration of operating PC:
- Windows NT or Windows 2000