Lectra Alys 30 - Updating Plotter Electronics Management Program

 %GGIWWXSXLIEHZERGIHQEMRXIRERGIWSJX[EVI
%P]WQEMRXIRERGIQERYEP %%
!
$FFHVVWRDGYDQFHGPDLQWHQDQFHLVUHVWULFWHGWR/HFWUD
PDLQWHQDQFHWHFKQLFLDQV
7RJDLQDFFHVVWKHWHFKQLFLDQZLOOQHHGWRREWDLQDQDFFHVVFRGH
IURP/HFWUDVXSSRUWVHUYLFHV
A dialog box appears on the screen:
 9THEXMRKTPSXXIVIPIGXVSRMGWQEREKIQIRXTVSKVEQ
The update will be required in the following cases:
- replacing the electronics board,
- the three LEDs on the keyboard are ON (following a problem on the
electronics board),
- update of the software using Alys and requiring plotter electronics
management update,
- update of electronics management in an attempt to improve or correct bugs.
*EMPWEJIQSHI
,IWKHWKUHH/('VRQWKHFRPPDQGNH\ERDUGUHPDLQ21WKHSORWWHU
HOHFWURQLFVPDQDJHPHQWSURJUDPZLOOQHHGWREHUHORDGHG,QWKLV
FDVHWKHk)DLOVDIHPRGHyLVVHOHFWHGE\GHIDXOWZKHQ$O\V([SHUW
VWDUWV
Access to tools to test the plotter will be available only after the plotter
electronics management program is updated.
In some instances, activating the “Fail-safe mode” may be required in order
to update the program installed for the plotter. To activate this mode,  check
“Fail-safe modeEHIRUH clicking the OK button.
)RXIVXLITEWW[SVHTVSZMHIHF]
0IGXVELIVI
'PMGOXS
GSRJMVQ
8LI0IGXVEXIGLRMGMER[MPP
IRXIVLMWLIVREQILIVI