Lectra Alys 30 - 3.3 Dismantling the buffer reservoir

(MWQERXPMRKSJTVMRXMRKFPSGOTEVXW 
%% %P]WQEMRXIRERGIQERYEP
 (MWQERXPMRKXLIFYJJIVVIWIVZSMV
1. If necessary, unplug the ink level sensor cable from the electronics board
(see below).
2. Unscrew the lock nut from the ink entry tube on the reservoir.
!
.HHSWKHVHDO0DNHVXUHQRWWRORVHLW
!
%HFDUHIXOQRWWRVSLOOLQNRQWKHPDFKLQHRURQ\RXUFORWKHV
3URWHFWWKHHQGVZLWKDGKHVLYHWDSH
3. Remove the ink delivery tube from its housing
4. Unscrew the buffer reservoir fastening screws, situated outside the
plotting block casing




7IIl6IQSZEPSJXLILIEHFYJJIV
VIWIVZSMVYRMXzXSVIQSZIXLI
VIWIVZSMVFYJJIVEWWIQFP]IUYMTTIH
[MXLXLIHMWGSRRIGXIHTVMRXIVLIEH
