Lectra Alys 30 - Operating Voltage of Plotter

ZMMM 3TIVEXMRKZSPXEKISJTPSXXIV
%P]WQEMRXIRERGIQERYEP %%
 3TIVEXMRKZSPXEKISJTPSXXIV
!
%HIRUHVZLWFKLQJRQWKHSORWWHUFKHFNWKDWLWVRSHUDWLQJYROWDJHLV
FRUUHFW7KHSORWWHULVVXSSOLHGFRQILJXUHGIRUDPDLQVYROWDJHRI
9
To change the plotter’s serviceable voltage, simply invert the protective fuse
cartridge, which is located underneath the entry point of the mains cord.
 1EMRWGSVH
 )YVSTIERGSYRXVMIW
The mains cord supplied with Alys plotters conforms with European safety
standards.
 97%ERH'EREHE
Le cordon d’alimentation du traceur Alys doit être du type :
3-core type SJT, rated 18 AWG minimum for 10A, 250V.
The plotter's
operating voltage
corresponds to the
voltage indicated by
the arrow next to the
locating mark on the
fuse cartridge.
220 - 240v
110-120V