5. Indicator Light and Alarm Sounds
Robot Status
Indicator Light
Charging
Glows a solid PINK or BLUE
Finished ChargingThe BLUE goes out
Has a Problem
Flashes RED or glows a solid RED
Low BatteryGlows a solid RED
Cleaning Mode
Glows a solid BLUE
Before starting network pairing
Glows a solid BLUE
network pairing process/WiFi connection was lost
Exit the network pairing mode after 3minutes,
the BLUE goes out
Connect to Wi-FiGlows a solid BLUE
5.1 Indicator Light
5.2 Alarm Tips
No.
Cause of issue
Motor Fan abnormal
Side Brush abnormal
Driven wheel abnormal
3
2
1
4
5
3
2
1
BeepsAPP Error prompts and solutions
Glowing a solid RED
When the robot fails, the robot indicator flashes red and a beeping sound of varying lengths is emitted.
Refer to the following table to query the cause of the failure:
Please wipe the Charging Contacts and Charging Dock Pins,
otherwise replace the adapter.
Manually place the robot on the Charging Dock to charge.
Place the robot on an even surface, or remove the obstacles,
and restart the robot.
The robot is floating, please move to the ground.
2 beeps 3 times
3 beeps 3 times
4 beeps 3 times
5 beeps 3 times
6 beeps 3 times
Please check if the Power Switch is on.
Flashing RED
1 beep 3 times
2 beeps 3 times
3 beeps 3 times
Please empty the Dust Bin, clean the Filter Net and High
Efficiency Filter.
please check if the Side Brush is entangled,
and clean the Side Brush
Please check whether the Driving Wheels is entangled
and clean the Driving Wheels.
If the trouble cannot be eliminated according to the above operation, Please try the following
operations Re-open the Power Switch on the side of the robot and restart the robot.
Please contact support@lefantlife.com.
Charging voltage abnormal
Low Battery
Failure to get out of trouble
Anti-drop detection alarm
Charging abnormal
17
To Next Page
Loading...
