15
If the above methods don't resolve the problem, try the following: Hold the start/pause button on the robot for 12 seconds. After hearing a long
"beep", turn off, then long press for 3 seconds to restart.
<MJSYMJWTGTYWZSXNSYTYWTZGQJNYXWJINSINHFYTWQNLMY\NQQGJTSTWƵFXMFSIGJJU\NYMINKKJWJSYIZWFYNTSXFSI
separations. The following table summarizes the corresponding causes:
4. Abnormal symptoms / 4.1 Symptoms prompts
The red light is on
Fault cause
Abnormal fan
Abnormal side brush
Abnormal driving wheel
Undetected dust bin
3
4
2
1
No.
4
3
2
1
Red light flashes
Solutions
Please check the waste in the dust bin and the air duct.
Please check whether the side brush is tangled , and clean up the side brush.
Please check whether the driving wheel is tangled , and clean up it.
Please install the dust bin in the robot.
Clean the electrode and ensure the original adapter.
Please move the robot to the docking station for charging.
+FNQYTLJYWNITKFINQJRRF UQJFXJRT[JYTFSTUJSUQFHJ
The robot hangs in the air. Please move it to the ground.
Prompt sound
3 beeps for three times
5 beeps for three times
Abnormal recharge
5
Abnormal charging, please manually move the main unit to the charging
cradle for charging.
6 beeps for three times
2 beeps for three times
1 beep for three times
5 beeps for three times
4 beeps for three times
3 beeps for three times
2 beeps for three times
Abnormal adapter
1T\'FYYJW^
Dilemma elimination alarm
Ground-detection alarm