LEGRAND celiane - Operation Modes

SCS BUS AUTOMATION SYSTEM
CONFIGURATION
III-144
Key cover Configurator value (M) Function performed
Main control operating modes
The devices installed within the automation system may perform
different operations, such as light intensity adjustment, switching
on/of of lights, or opening/closing of shutters. The definition of
the function performed, i.e. what function must be performed
by the device, is set by fitting the configurators in the M marked
housings of the control devices, together with the appropriate
key covers (for flush mounting only devices). The following table
shows the various operating modes based on the configurator
and the type of key cover used in the device.
M
M
ON
M
OFF
M
O/I
M
M
M
M
M
SLA
M
SPE
1√8
1√8
PUL
1√8
M
1√4
M
configurator OFF
no configurator
M
M
ON
M
OFF
M
O/I
M
M
M
M
M
SLA
M
SPE
1√8
1√8
PUL
1√8
M
1√4
M
configurator M
configurator
configurator PUL
M
M
ON
M
OFF
M
O/I
M
M
M
M
M
SLA
M
SPE
1√8
1√8
PUL
1√8
M
1√4
M
M
M
ON
M
OFF
M
O/I
M
M
M
M
M
SLA
M
SPE
1√8
1√8
PUL
1√8
M
1√4
M
M
M
ON
M
OFF
M
O/I
M
M
M
M
M
SLA
M
SPE
1√8
1√8
PUL
1√8
M
1√4
M
configurator O/I
M
M
ON
M
OFF
M
O/I
M
M
M
M
M
SLA
M
SPE
1√8
1√8
PUL
1√8
M
1√4
M
M
M
ON
M
OFF
M
O/I
M
M
M
M
M
SLA
M
SPE
1√8
1√8
PUL
1√8
M
1√4
M
configurator ON
Cyclical ON-OFF control
Repeatedly pressing the relay actuators device key cover, ON and OFF controls will be sent in a cyclical way. With dimmer actuators,
keep the pushbutton pressed to adjust the load power.
ON control
When pressing the corresponding key cover, the device sends the ON control.
OFF control
When pressing the corresponding key cover, the device sends the OFF
control.
Monostable ON-OFF control (pushbutton)
This mode can perform an ON/OFF control similar to the control of a traditional point-point pushbutton, thus intended just for one
address.
Bistable control with hold (UP-DOWN for rolling shutters)
Pressing the key cover (lower or upper) sends the UP-DOWN control to the rolling shutter motor. After the control has been sent, press
the lower or upper key cover again, to stop the rolling shutter in the required position.
Monostable control (UP-DOWN for rolling shutters)
The device sends an UP-DOWN control for a rolling shutter motor as long as the lower or upper key cover is pressed. When the key
cover is released, the motor STOPS.
ON/OFF control
Used with relay actuators, when the upper key cover is pressed the device sends an ON control; when the lower key cover is pressed
the device sends an OFF control.
With dimmer actuators, pressing the upper and lower key cover adjusts the load power.
Push button mode
Switch mode
Operation modes
Table
CEN
The device activates the advanced scenarios saved in 035 65.
configurator CEN
M
CEN