LEGRAND celiane - Room Control

SCS BUS AUTOMATION SYSTEM
CONFIGURATION
III-142
Room 1
Room 1 Room 2
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
Actuators
Point-point
control
Point-point
control
Actuators
Room 2
Room 2
control
Room 1
control
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
A = AM B
PL = 1
A = AM B
PL = 2
Room 1
Room 1 Room 2
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
Actuators
Point-point
control
Point-point
control
Actuators
Room 2
Room 2
control
Room 1
control
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
A = 1
PL = 1
A = 1
PL = 2
A = 1
PL = 3
A = 2
PL = 1
A = 2
PL = 2
A = 2
PL = 3
A = AM B
PL = 1
A = AM B
PL = 2
Control directed to one actuator only, identified with a “room number” and a “light point number”.
Control device: A = n* PL = n*
Actuator: A = n* PL = n*
In order to better clarify the concepts outlined in the previous page, below is an explanation of the four addressing mode.
The control devices (senders), enable the activation of the actuators (receivers), with the following modes:
Example: control of all the lights in a room
n* = any numeric configurator from 1 to 9
Addressing levels
Example: control of a single load (lamp, fan, rolling shutter, etc.)”
Point-point control
Room control
Control sent to all actuators identified with the same room number.
Control device: A = AMB PL = n*
Actuator: A = n* PL = n*