LEGRAND Wattstopper LMCP8 - Status; Panel and Device Status Overview

25
Display Description Press
OccSensor: <1>
On Action: <On>
Off Action: <Off>
Group: <1>
Occ Sensor Event 1
ACTIVE DAYS DONE
Select the number of the OccSensor assigned
to the event. Sensor numbers are automatically
assigned based on serial number with the highest
number set to 1, next highest set to 2, etc.
Set the On Action (sensor detects occupancy)
and Off Action (sensor detects vacancy). For each
action, the loads in the group can be set to turn
ON, turn OFF, or do nothing).
NOTE: Whether the load responds to the sensor
message is determined by the two sensor
related parameters that are part of the
group. So, for example, if Sensor NH is
set to Manual On/Auto Off, the load will
respond to the Off Action but not the On
Action during Normal Hours.
Set the Group that the event is assigned to. Then,
highlight ACTIVE DAYS and press Select
then choose
ACTIVE DAYS
and press Select
or
to move to each
parameter
or
to change the value
of the parameter
Mon: <Y> Tue: <Y>
Wed: <Y> Thu: <Y>
Fri: <Y> Sat: <N>
Sun: <N> Holiday: <N>
Occ Sensor Active On
DONE
For each day of the week, select whether
response to sensor input will be active (Yes or
No). Additionally, select whether the event will be
active on holidays. (You determine which days are
holidays in the Holidays screen.)
Highlight DONE and press Select to return to the
Occ Sensor Event x screen. Then select DONE
again to return to the OccSensor Event screen.
then choose
DONE and
press Select
or
to move to each
parameter
or
to change the value
of the parameter
Event Number: <1>
OccSensor Event
NEXT DONE DELETE SEND
Highlight SEND and press Select.
Once again, point the LMCT-100 at the infrared
sensor on the LMRD board and press Select. You
return to the Group Setup screen, where you can
program the next group.
When finished, highlight DONE and press Select to
return to the OccSensor Event screen.
to choose
SEND and
press Select
or
Status
The Status option includes several different screens which provide information about the panel and networked devices:
• Panel Status – Displays the date and time, based on the panel settings, along with additional information.
• Load Status – Displays details about each load in the panel, as well as any loads in connected room controllers.
• Group Status – Displays which loads are assigned to each group, programming details for the group, and differences for loads that
may have different settings from the group settings..
• Light Level – Displays the current light level of any photo sensors connected to the network.
• Occupancy Sensors – Displays the current state of any occupancy sensors connected to the network.
Display Description Press
Location Settings
Date and Time
Network
Button Binding
Panel Programming
Status
Panel Setup
From Panel Setup, scroll to Status. Press Select .
then
Select
Panel Status
Load Status
Group Status
Light Level
Occupancy Sensors
Status
DONE
Highlight the Status option you want to view and
press Select.
When finished, highlight DONE and press Select to
return to the Panel Setup screen.
then
Select