Leica FlexLine - Starting Peg Survey

Peg Survey FlexLine/FlexLine plus, 11
2.2 Starting Peg Survey
Access 1. Select Programs from the Main Menu.
2. Select PegSurvey from the Programs menu.
3. Complete the application pre-settings by:
• Selecting a job, and
• Confirming the set of tolerances. Refer to "1.2 Selecting Tolerance Profiles".
4. Select Start to proceed to Input Station.
Input station step-
by-step
Step Description
1. Enter the point ID of the station (Station:).
2. For manual entry of instrument height:
• Enter instrument height (hi:) of the station.
For measuring the instrument height:
• Turn the telescope to the azimuth with the help of the displayed
vertical angle (V:).
• Press Meas hi to measure distance to the peg.
)
The sign for the instrument height is normally negative.
3. Press Cont to set the station and instrument height.