EN
168
Picture mode
Metering memory lock
For composition reasons, it can be benefi cial not to have the main
subject in the center of the picture.
In these cases, metering memory lock - in exposure modes
P , T
and
A, and single fi eld and spot metering AF modes and focusing
by touch - allows you to fi rst take a reading for the main subject
and then retain the relevant settings until you have selected your
fi nal trimming and are ready to take the picture.
Taking a picture with this function:
► Aim the relevant AF frame at the part of your subject you want to
adjust the sharpness and exposure to.
► Press the shutter release to the fi rst pressure point to set and
store the sharpness and exposure.
► Hold the shutter release half way down and move the camera to
set your fi nal trimming.
► Press the shutter release all the way down to take the picture
Exposure compensation
Some subjects consist predominantly of areas of above or below
average brightness, for example extensive areas of snow or,
conversely, a full-format black steam locomotive. With
P , T and A
exposure modes, it may be more benefi cial in these situations to
set a corresponding exposure compensation instead of using
metering memory lock each time. The same applies to situations
where you want to ensure that several pictures have identical
exposure. Values from +3 to -3EV in
1
/
3
EV increments are
available.
► Select
► In the submenu, make the required setting on the scale using
or the right adjusting dial
► Press SET to confi rm
If the
EV
function is assigned to the left adjusting dial, it can be
used to directly select the compensation value.
• If a compensation value is set, it is displayed in the monitor, e.g.
EV+3. During setting, you can observe the eff ect as the monitor
screen becomes darker or lighter accordingly.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
