THROUGH DOVETAIL PROCEDURES
26
Chapter 8 Super Jig-12-18-24 User Guide
8-33 The box should be square and in plane. If it is not in plane
(i.e., the side edges of each board are not in line), then either the
ends of the boards are not square, the board widths are not exactly
equal, or there is a concentricity problem (see 7-2 to 7-9).
8-34 To form angled dovetails, refer to the Technical bulletin
“How to Rout Angled Through Dovetails on your Leigh Jig”. You
can download a printable file of the bulletin from our website:
www.leighjigs.com
■
To Next Page
Loading...